5.5kw-500kw 1~2500nm AC Motor Servo Drive

We produce high-quality Delta Ac Servo Driver, Load Cell Module, Robot Joint Actuator at low prices, creating diverse new series to meet market and customer needs. We break down these barriers to ensure you get what you want to the level you expect, when you want it. Based on the principle of proactive and honest management, our company provides high-quality products and services to customers all over the world to create a better future!

 Parameter table

The above parameters are for reference only. Our product technology is constantly updated and upgraded. At the same time, we also accept the customization and development of customers.

3.Product details

4. Factory and qualification

5. Instructions and precautions      

 Fault reason: the command signal is not to the driver signal ground.            

Processing method: connect the command signal ground with the driver signal ground.           

 Fault: after power on, the LED of the driver is not on            Fault reason: the power supply voltage is too low, less than the minimum voltage requirements.            

Treatment: check and increase the power supply voltage.           

 Fault: when the motor rotates, the LED light flashes            

1. Fault reason: Hall phase error.            

Treatment: check whether the motor phase setting switch (60? / 120?) is correct. Most brushless motors have a 120? Phase difference.            

2. Fault cause: Hall sensor failure           

 Treatment method: detect the voltage of hall a, Hall B and Hall C when the motor rotates. The voltage should be between 5VDC and 0.            

Fault: LED remains red all the time           

 Cause of failure: there is a fault.            

Treatment method: cause: over voltage, under voltage, short circuit, overheating, driver forbidden, hall invalid.

In the use of servo system, can servo-on be used as the signal to control the motor off-line so as to directly rotate the motor shaft?            

Although the motor can be offline (in free state) when the srv-on signal is disconnected, do not use it to start or stop the motor. Frequent use of it may damage the drive. If the off-line function needs to be realized, the switch of control mode can be adopted: assuming that the servo system needs position control, the control mode selection parameter no02 can be set to 4, that is, the first mode is position control, and the second mode is torque control. Then C-mode is used to switch the control mode: in position control, the signal C-mode is opened to make the driver work in the first mode (i.e. position control); when it is necessary to be offline, the signal C-mode is closed to make the driver work in the second mode (i.e. torque control). Because the torque command input trqr is not connected, the motor output torque is zero, thus realizing offline.

With our leading technology at the same time as our spirit of innovation, mutual cooperation, benefits and development, we are going to build a prosperous future alongside one another with your esteemed enterprise for 5.5kw-500kw 1~2500nm AC Motor Servo Drive. Our company relies on continuous technical improvement and excellent product performance. We have a lot of customers in many countries.

Hot Tags: ac servo drive, China, manufacturers, suppliers, wholesale, custom, high quality, Electric Brushless Motor, Xenon Disinfection Robot, Mecanum Omnidirectional Wheel, Autonomous Robot Platform, 5 Channel Flame Sensor, Intelligent Inspection Robot