Asd-B2-1521-Bdelta AC Servo Drive & Motor Asd-B2-0721-B / Ecma 0.1kw-3kw 220V

We have been fully committed to supplying our consumers with competitively priced high-quality goods, prompt delivery and skilled provider for Delta Servo Drive, High Speed Brushless Dc Motor, UVD Robot. With the rapid development of cutting-edge manufacturing technology and modern information technology, the customization of products was pushed forward at high speed. We strive to achieve the common development of the company and society, and help each other on the road of development to achieve a win-win goal. We will effectively apply customer demand trends learned through various exhibitions to product development.

 Parameter table

The above parameters are for reference only. Our product technology is constantly updated and upgraded. At the same time, we also accept the customization and development of customers.

3.Product details

4. Factory and qualification

5. Instructions and precautions      

 Fault reason: the command signal is not to the driver signal ground.            

Processing method: connect the command signal ground with the driver signal ground.           

 Fault: after power on, the LED of the driver is not on            Fault reason: the power supply voltage is too low, less than the minimum voltage requirements.            

Treatment: check and increase the power supply voltage.           

 Fault: when the motor rotates, the LED light flashes            

1. Fault reason: Hall phase error.            

Treatment: check whether the motor phase setting switch (60? / 120?) is correct. Most brushless motors have a 120? Phase difference.            

2. Fault cause: Hall sensor failure           

 Treatment method: detect the voltage of hall a, Hall B and Hall C when the motor rotates. The voltage should be between 5VDC and 0.            

Fault: LED remains red all the time           

 Cause of failure: there is a fault.            

Treatment method: cause: over voltage, under voltage, short circuit, overheating, driver forbidden, hall invalid.

In the use of servo system, can servo-on be used as the signal to control the motor off-line so as to directly rotate the motor shaft?            

Although the motor can be offline (in free state) when the srv-on signal is disconnected, do not use it to start or stop the motor. Frequent use of it may damage the drive. If the off-line function needs to be realized, the switch of control mode can be adopted: assuming that the servo system needs position control, the control mode selection parameter no02 can be set to 4, that is, the first mode is position control, and the second mode is torque control. Then C-mode is used to switch the control mode: in position control, the signal C-mode is opened to make the driver work in the first mode (i.e. position control); when it is necessary to be offline, the signal C-mode is closed to make the driver work in the second mode (i.e. torque control). Because the torque command input trqr is not connected, the motor output torque is zero, thus realizing offline.

We always get the job done to be a tangible staff to ensure that we can easily offer you the best high-quality and the greatest value for Asd-B2-1521-Bdelta AC Servo Drive & Motor Asd-B2-0721-B / Ecma 0.1kw-3kw 220V. We warmly welcome domestic and overseas customers send inquiry to us, we have 24hours working team! Welcome all nice buyers communicate details of products with us!!

Hot Tags: ac servo drive, China, manufacturers, suppliers, wholesale, custom, high quality, Servo Motor, Autonomous Mobile Robot, Logistics Robot, Hyper Light Disinfection Robot, Articulated Robot Joint Kit, Mobile Logistics Robot