Panasonic AC Servo Drive Mbdht2510e

We warmly welcome friends from all walks of life to come to our company for inspection and guidance, and are willing to jointly contribute to the development of UV Ligth Disinfection Robot, Industrial Mecanum Wheel, Small AGV Robot on the basis of mutual benefit. We are confident that we are going to share mutual achievement and create strong co-operation relations with our companions in this marketplace. We warmly welcome clients from all over the world coming over for a visit and establishing long term relationship.

 Parameter table

The above parameters are for reference only. Our product technology is constantly updated and upgraded. At the same time, we also accept the customization and development of customers.

3.Product details

4. Factory and qualification

5. Instructions and precautions      

 Fault reason: the command signal is not to the driver signal ground.            

Processing method: connect the command signal ground with the driver signal ground.           

 Fault: after power on, the LED of the driver is not on            Fault reason: the power supply voltage is too low, less than the minimum voltage requirements.            

Treatment: check and increase the power supply voltage.           

 Fault: when the motor rotates, the LED light flashes            

1. Fault reason: Hall phase error.            

Treatment: check whether the motor phase setting switch (60? / 120?) is correct. Most brushless motors have a 120? Phase difference.            

2. Fault cause: Hall sensor failure           

 Treatment method: detect the voltage of hall a, Hall B and Hall C when the motor rotates. The voltage should be between 5VDC and 0.            

Fault: LED remains red all the time           

 Cause of failure: there is a fault.            

Treatment method: cause: over voltage, under voltage, short circuit, overheating, driver forbidden, hall invalid.

In the use of servo system, can servo-on be used as the signal to control the motor off-line so as to directly rotate the motor shaft?            

Although the motor can be offline (in free state) when the srv-on signal is disconnected, do not use it to start or stop the motor. Frequent use of it may damage the drive. If the off-line function needs to be realized, the switch of control mode can be adopted: assuming that the servo system needs position control, the control mode selection parameter no02 can be set to 4, that is, the first mode is position control, and the second mode is torque control. Then C-mode is used to switch the control mode: in position control, the signal C-mode is opened to make the driver work in the first mode (i.e. position control); when it is necessary to be offline, the signal C-mode is closed to make the driver work in the second mode (i.e. torque control). Because the torque command input trqr is not connected, the motor output torque is zero, thus realizing offline.

We are committed to provide the market with the most sophisticated Panasonic AC Servo Drive Mbdht2510e as we constantly adjust the product structure with our long-term accumulated experience and advanced technology from a wide range of fields. Our company continues to absorb advanced mature technology and develop new products according to market demand. Our advantage lies in our design, production, and sales capabilities, and diverse technologies, which will certainly meet your needs.

Hot Tags: ac servo drive, China, manufacturers, suppliers, wholesale, custom, high quality, All Terrain Robot, Wheeled Mobile Robot, Brushless DC Motor, Automated Guided Vehicle, Temp Sensor, Autonomy Patrol Security Robot